New Lidar Tech Approved for Use by SGRE for Wind Turbine Testing

MTR
Wednesday, October 21, 2020

Siemens Gamesa recently tested a new technology together with ZX Lidars, and based on the results both on the medium range and long range measurements, Siemens Gamesa Renewable Energy (SGRE) approves the use of the nacelle-based Continuous Wave scanning Lidar ‘ZX TM’ from Lidar OEM ZX Lidars for Power Performance Testing.

In addition, operational ‘rotor equivalent’ power curves can also be measured with ZX TM’s 50 points around the full rotor swept area, particularly important for turbines with larger rotor diameters offshore and on onshore sites with complex veer or shear profiles.

This specific Lidar - ZX TM - allows the power curve of SGRE wind turbines to be measured and verified as a function of the Hub Height wind speed and may be, when agreed with the customer, used instead of the procedure described in the IEC61400-12-1:2017 (ed. 1/ed. 2) using a meteorological mast and anemometry installation.
Image courtesy ZX Lidars

Categories: Technology New Products Products Offshore Energy Renewable Energy Offshore Wind LIDAR

Related Stories

Carnegie's CETO Wave Energy Unit Hits Water off Spain

Six Oyster Hubs Installed at Ecowende Wind Farm to Support Ecosystem Recovery

HPR Secures Taiwan Offshore Wind Deal After High-Current ROV Trials

Current News

Chevron Vessel Begins Gas Survey Offshore Greece

ExxonMobil Greenlights $4B Kizomba Revamp with Fresh Discovery off Angola

Japan's KEPCO Joins 390MW Polish Offshore Wind Project

Türkiye Set for Offshore Seismic Surveys in Pakistan Ahead of 2027 Drilling

Subscribe for OE Digital E‑News